Storing Scanned Images on a USB Device or SD Card

Use these steps to scan your whiteboard notes and store them to a USB flash device or SD card. 

1. Set the Power Switch to the On ( | ) position.  (The Power Switch is on the left side of the control panel.)
2. Connect the USB flash device or insert the SD card.
   Note: The USB Flash Device port is labeled Memory and is located on the right-side of the Control Panel.  The SD card slot is at the front of the Control Panel.
3. A USB or SD icon will blink on the display while the device is loading.  When it is ready, the icon will go to a steady display. 
4. Press the Mode Key to select the scan mode (e.g., Color-Fine/Normal, B/W-Fine/normal). 
5. Press the Start/Stop Key.  The unit will begin scanning and display the scan status in the display area of the Control Panel.  When the scan is complete, the scanned image is displayed on the Control Panel.
   DO NOT remove the USB flash device until the scanned image displays on the Control Panel. 
   

Important:

• If you press the Start/Stop key and a USB flash device or SD card is not connected to the whiteboard, the scan will not start.
• If the scanner does not respond, the USB device or SD card you are using may not be supported.  Please visit http://panasonic.co.jp/pcc/products/en/eboard/color/ub2815c.html for a list of supported memory devices.
• If your SD card was previously formatted, it may not be recognized by this unit. Please visit http://panasonic.co.jp/pavc/global/cs/sd/download/sd_formatter.html to download the formatting software to reformat the SD card.